December 12, 2018, 01:21:23 AM
Welcome, Guest. Please login or register
News: Stay up to date with everything that's happening at http://plus.digitalsignage.com

MediaSignage support forum



Author Topic: 2 or more HDMI signals from single player  (Read 1744 times)

Jeda

  • Newbie
  • *
  • Posts: 11
  • Karma: +0/-0
    • View Profile
2 or more HDMI signals from single player
« on: May 30, 2012, 05:32:21 PM »
We are currently in the process of transition our old digital signage system to mediaSignage using mediaBoxes.  Our current system in player run from a digital signage box out to a splitter that feeds 4 TV screens. We also have the same setup using DVD players with HDMI outs.  However, when we swap the mediaBox in there place, the signal fails to feed out.  I can get a signal if I bypass the splitter and only go to one TV. If I split the signal between two TVs on will have lost of noise in the picture and the second will just flicker on and off.  I take it there isn't enough power coming out of the Graphics board.  Is there anyway to get a better signal?

(just a side note, I have to use HDMI because the entire building was built with HDMI ports to all the mounted TV screens)

Thanks

admin

  • Administrator
  • Hero Member
  • *****
  • Posts: 4877
  • Karma: +35/-8
    • View Profile
Re: 2 or more HDMI signals from single player
« Reply #1 on: May 31, 2012, 04:24:05 AM »
Try using an active HDMI splitter one that amplifies the signal and has is own power source.

 

Carbonate design by Bloc
variant: carbon
SMF 2.0.12 | SMF © 2016, Simple Machines